Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Buchanan on July 07, 2013, 11:01:12 PM
-
Help.
I have had Mach 3 demo running a Gecko 540 and four stepper motors on the work bench in preperation for fitting to a mill. This worked fine.
My mill is now ready and I bought my Mask licence. Now when I try to run my stepper motors only two work and and they only run in one direction even when I jog them in either direction. The DRO's on the screen work correctly and I can swap around the motors but the problem remains on the same axis so my motors are ok.
Where do I look now ,please.
Buchanan
-
I am so thick.
I went through my pins and ports and they were all over the place so i reset them and all is well.
Buchanan