Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: emi on June 27, 2013, 04:43:10 PM
-
Hey i need help with setting up 4axis hot wire I'm
using g540 gecko 4axis setup.
I have X and A as a slave i can jog 2 motors with up or down arow
How do i slave Y and B axis so i can jog in sync with lets say arrow key?
i did try sys hotkeys set same key for Y y++38 y-40 B b++38 b-40 no results only one motor moves
Did try formulas put f(y)=b still nothing.
amateur at best need help!