Machsupport Forum

Mach Discussion => FAQs => Topic started by: jg156 on June 21, 2013, 11:47:54 AM

Title: Stepper motor issues after calibration
Post by: jg156 on June 21, 2013, 11:47:54 AM

Hi, I'm new here.
my motors were running fine (though uncalibrated)
after i calibrated an axis, the motor stopped running, and now instead issues a beep
for the duration of the time it is supposed to be running.
any ideas?

Title: Re: Stepper motor issues after calibration
Post by: rdean on June 21, 2013, 02:27:51 PM

Check your acceleration is not set too high the motor may be stalling.

Ray