Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DonMarkey on June 20, 2013, 09:12:54 PM
-
Can I share multible home switches on one input. Right now I use one prox with 2 flags one for + and - limit/home switches and it homes fine. But I am out of inputs and want to add some things without going to modbus or something like that. So can I use one input for mulitble axis? I know it will work electrically but will it work in mach or will I get a limit trip when homing?
Thanks,
Don
-
Yes, you can wire all of your home switches and limits switches to one input if you want. The reason it can still home correctly is because Mach follows a routine when homing. It isn't looking for a particular switch, it is looking for a change of state and they can all be on the same input. If anyone of them trips while not homing it will throw a limit switch fault.
Brett
-
Thanks that was what I was hoping for. I knew mach disreguarded the limits while homing just didn't know if it was all limits during the whole homing process or an axis by axis basis.
Don