Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: cowpoke on February 18, 2007, 11:54:12 AM
-
Very interesting discussion on the CNC Zone site about a new servo controller developed in Germany. Maybe this might wake up Rutex and get them in the "service and supply" mode again.
You can follow it at,
http://www.cnczone.com/forums/showthread.php?t=14217
If anyone has experience with this drive please respond as I have a current need. A great deal of the information is in German so any assistance is appreciated.
Claude
???