Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: magnetron on June 11, 2013, 02:44:04 PM

Title: how to integrate my own motion control hardware to mach 3 ?
Post by: magnetron on June 11, 2013, 02:44:04 PM
hello dear forum ,

I want integrate my own hardware ( motion control PLC ) ( photo below link ) to mach 3

http://www22.brinkster.com/anotherbrick/index15.htm

I am totally new to this area
can you please show me a roadmap ?
how can I integrate my own hardware to mach 3 ?
where to start ?
which forum to ask ?

thank you
Title: Re: how to integrate my own motion control hardware to mach 3 ?
Post by: Hood on June 11, 2013, 03:10:36 PM
You would need to write a plugin so the plugin section of the forum would be the most likely place you will get help. http://www.machsupport.com/forum/index.php/board,28.0.html
There is a I believe a SDK on the Mach downloads page. http://www.machsupport.com/downloads.php
Hood