Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: bill-the-cat on June 05, 2013, 03:44:06 PM

Title: Problems with screen size after update
Post by: bill-the-cat on June 05, 2013, 03:44:06 PM
I just updated from 3.042.020 to 3.043.066 and the Mach screen no longer fills my monitor.  I am using the same XML that I was using with the old version and Auto Screen Enlarge is checked on the General Config page, but the Mach screen is no longer filling my monitor screen.  I copied the Mach folder before the update and if I run the old version of Mach, the auto enlarge works.   Can anyone help?
Title: Re: Problems with screen size after update
Post by: ger21 on June 05, 2013, 04:57:50 PM
Did you close and restart Mach3?
Title: Re: Problems with screen size after update
Post by: bill-the-cat on June 05, 2013, 05:07:40 PM
I closed and restarted Mach3 and I even rebooted the computer.  No luck.
Title: Re: Problems with screen size after update
Post by: ger21 on June 05, 2013, 05:25:06 PM
Do you have Mach3 maximized?
Title: Re: Problems with screen size after update
Post by: bill-the-cat on June 05, 2013, 05:51:45 PM
That was it.  I had tried maximizing before and it simply expanded the window but the Mach screen itself stayed the same size....so I had always switched it back.  This time I closed Mach with the window maximized (even though the Mach screen was still undersized) and then restarted..... it now fills the screen.

Thanks for making me think!