Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: rkonnen on May 31, 2013, 09:25:13 AM
-
Can Mach read and/or display tempurature? If so, how.
-
It depends what your temp sensors signal is, for example you can input analogue voltages with certain devices, I use a PLC with analogue inputs on some machines and on others I can take them in directly o the controller (CSMIO/IP-A , IP-S and IP-M)
The pokeys can also be used to get analogue inputs into Mach but it is just 0-3v (or possibly 0 to 5v) where the other ones I mentioned above are 0-10v.
Once you have that signal in Mach you can do what you want via a Brain or the Macropump.
Hood
-
So the hardware is needed for A/D conversion?
-
Yes.
Hood