Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ugotit33 on May 31, 2013, 09:23:33 AM

Title: Learning curve #2 for new learner like me.
Post by: ugotit33 on May 31, 2013, 09:23:33 AM

Since I setup my machine last night and did a few test's
See previous pictures.
I tried another test this morning.
First time using V carve.
Setup the drawing in inches
Drew 4 circles from center out  total 4" diameter.
Created a DFX turned it into a c-code. ETC
Work good since I'm still learning.
Nice to see the display path and DRO'S as machine moves and work cutting,
and follow the g-code
Drew circles around the Road runner from a previous test
when testing my machine
Hope this helps some one get excited to try experiments.