Machsupport Forum

Mach Discussion => Non English Forums => Spanish => Topic started by: Ing_Irvingcnc on May 25, 2013, 01:38:43 PM

Title: COMO CONFIGURAR MACH3 CON ESTA INTERFACE
Post by: Ing_Irvingcnc on May 25, 2013, 01:38:43 PM

(http://i00.i.aliimg.com/wsphoto/v0/505511950/5-axis-CNC-Breakout-board-interface-board-Card-MACH-EMC2-KCAM4-for-Stepper-Motor-Drive.jpg)

Title: Re: COMO CONFIGURAR MACH3 CON ESTA INTERFACE
Post by: Tweakie.CNC on May 27, 2013, 05:45:13 AM

¿Que es (Fabricante / modelo)

Tweakie.

Title: Re: COMO CONFIGURAR MACH3 CON ESTA INTERFACE
Post by: valvulin on May 27, 2013, 02:05:24 PM

desconozco los datos de esa placa en particular, pero se ve muy sencilla, fijate que debe tener los N° de P1, P2, P3, etc etc,
esos son los pines que deberas setear en el MACH, normalmente del P2  al P9 conectaras tus drivers de motores, en P10, P11, P12, P13, los microswitch o boton de Emergencia o Stop, habria que ver el rel{e a que Pin está asignado, pero podes probar seteando el P14...

Suerte y despues nos cuentas..

Title: Re: COMO CONFIGURAR MACH3 CON ESTA INTERFACE
Post by: Ing_Irvingcnc on May 27, 2013, 02:29:54 PM

(http://img.alibaba.com/img/pb/444/827/515/515827444_460.jpg)

Title: Re: COMO CONFIGURAR MACH3 CON ESTA INTERFACE
Post by: turbicnc on October 12, 2013, 05:20:05 PM

CNC  Breakout Board adapter for PC Stepper Motor Driver
CNC interface board, you can make your computer into a powerful CNC controller!
 
5 axis Breakout board
Compatible: KCAM4 MACH EMC2
Built in DB25 male connector
It is with 4-wire limit switch to insure our safty movement
It is with relay port to contro the cnc spindle
Working voltage is 5VDC and support with MACH3,EMC2,KCAM4 software
Size:9x5.7cm
 ....................................................................
25-pin parallel port control is defined as follows:
DB25 control pin (PIN)    The pin of the drive board   Comment
 
1   STEPB   B(Fifth axis)pulse signal
2   STEPX   X(First axis) pulse signal
3   DIRX   X(First axis) direction of the signal
4   STEPY   Y(Secondaxis)pulse signal
5   DIRY   Y(Second axis)direction of the signal
6   STEPZ   Z(Third axis) pulse signal
7   DIRZ   Z(Third axis) direction of the signal
8   STEPA   A(Fourth axis) pulse signal
9   DIRA   A(Fourth axis) direction of the signal
10   LIMIT-1   Limit input interface 1
11   LIMIT-2   Limit input interface 2
12   LIMIT-3   Limit input interface 3
13   LIMIT-4   Limit input interface 4
14   DIRB   B(Fifth axis) direction of the signal
15   Vacant   
16   RLY   Relay control
17   EN   All axis enable
18-25   GND   GND