Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Mishawaka on May 19, 2013, 05:09:55 PM

Title: Stepper Motor sync
Post by: Mishawaka on May 19, 2013, 05:09:55 PM
I'm thinking of putting together a cnc plasma table. I'm on the fence about using one per side of x axis with rack and pinion or tie both side together with chains and sprockets using one motor. I prefer the two motor method because I think it's cheaper but not sure how to sync the motors together. Does Mach3 software automatically do that or is there any special configuration?
Title: Re: Stepper Motor sync
Post by: Hood on May 21, 2013, 07:02:51 AM
Yes you set up the motors as master and slave in Mach. It works extremely well as long as both motors and drive trains are the same.
Hood