Machsupport Forum

Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: peterc on May 15, 2013, 03:33:31 PM

Title: New Tool Table Save Error
Post by: peterc on May 15, 2013, 03:33:31 PM

I just installed licensed version 1.0.3.  I opened the tool table and added all the info for my tools.  Clicked the Save button and the program crashed.  This happened three time, once after rebooting the PC.
Debugger error report:

Unhandled exception at 0x01181dfa in NFS_Mill.exe: 0xC0000005: Access violation reading location 0x00000200.

Work around was to rename one of the default tool tables in the Users/Wizards/Mill/ToolTable folder.

Title: Re: New Tool Table Save Error
Post by: Ron Ginger on May 15, 2013, 06:30:45 PM

I cannot repeat this. Did you do it as the first operation, or did you start a job first? Did you instal it with all the defaults, or did you change some file location?

Is this repeatable on your system?