Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mvoros on May 03, 2013, 11:40:10 AM

Title: MY JCut 6090 retrofit for ethernet smoothstepper
Post by: mvoros on May 03, 2013, 11:40:10 AM
Hi All,
I have embarked on changing over from the way this Chinese router was built to Ethernet Smoothstepper. Why, because every job I started, the tool crashed into my work. I got these components from CNC4PC:
Ethernet Smoothstepper;  C25 bob;  C41 speed control board;  C22 pendant interface board;  MPG2.
Arturo even sent me a wiring diagram, that I followed to the letter. Wired most everthing, but now I'm stuck With the C22 and C25 wiring.
Arturo said the C22's instruction diagram won't work with the C25 breakout board, because it doesn't have EN terminal on it.
Can anyone help me with this problem please? I'm attaching an image of my wiring so far.
Mike Voros

[attachment deleted by admin]