Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Kenneth on April 30, 2013, 09:26:40 AM

Title: machine coor dro not working
Post by: Kenneth on April 30, 2013, 09:26:40 AM

I had mach coor(83) and work offsets(178)dro working before.
now they don't change while running program. mac coor 84,85
and offset 179,180 work as should. upgraded to 1.57 Monday(29)
I fixed the strange reading on dro(83) by deleting and inserting again.
Thanks

mach3 Ver. R3.043.062
machscreen ver. 1.57

Title: Re: machine coor dro not working
Post by: Kenneth on May 01, 2013, 10:04:15 AM

also, when I load a file and have messages in it, the Error label shows
all the messages. at the end of the file, the last message is "Finished",
so when I load the file "Finished" is in the Error label. but the file never ran.
so is there a way to get the label to not show the messages
unless the program is ran ?
Thanks