Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Sparc on April 25, 2013, 01:46:30 PM
-
Hi;
We want to use mach3 with the G41 and G42 codes. The wish is that if we push feed hold the torch goes off and the thc rises up. And then if "start" pushed that the system goes again.
It this in any way possible.
It would be nice if a tool dia ( kerf ) change will take effect after the "start"
Any ideas ?
Many thanks in advance
Selim
-
It is possible to do all that BUT you will have to write the support code to make it all work as you want it to.
(;-) TP