Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Sckizm on April 24, 2013, 01:34:00 AM
-
I have searched this forum for a while and cannot find someone with my issue. I was in the middle of a cut and then my cnc router stopped responding. I have gone as far as to uninstall and reinstall Mach3. I am at a loss. I'm using a G540 multiaxis step drive with NEMA 32 motors. According to Mach3 my motors are moving, but they aren't. When I press the arrows, the numbers change like normal. Please help!
-
I just realized that the power light on my G540 drive was not on. I'm going to try to replace it.