Machsupport Forum
Third party software and hardware support forums. => Mach3 and G-Rex => Topic started by: Len-Tikular on April 18, 2013, 03:51:45 PM
-
Finally!
I got my inductive proximity switches working correctly.
X Y & Z all go to the home position when the Home Key is pressed. Hooray!
Now the problem,
If I set the x--- to be the same as my X home. Now when triggered I cant Jog away from it to a safe position. ??
Message is correct saying 'Xlimit switch triggered' but pressing 'Reset' has no effect
Have I still got it wrong ?
Thanks
George
-
George, go to the settings page and enable the autolimits override. Top left.
Brett
-
Many thanks Bret, that's where it was hiding :-)
All working fine now.
Regards
George
-
:)
Brett