Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Stefan Eischer on April 16, 2013, 08:08:33 AM
-
Hi,
(I'm new to Mach3 so this is probably a stupid question)
Whenever I start Mach3 the E-stop is active and the Status line depicts the message "ReConfiguration Estop".
Why is that so?
I would like to run Mach3 in the background because it's only used for one of several modules of the machine.
Is there a way to start-up Mach3 without manually resetting the Estop?
-
That would be a safety thing Stefan and for that reason cannot be bypassed.
Ian