Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: dneisler on April 08, 2013, 08:28:50 PM
-
I have finally got my limit switches installed and working on my X3 using honeywell switches attached to a CNC4pc c11g board. They all seem to work fine, but my question is...
When a limit is triggered, shouldn't I be able to hit reset or something, and continue jogging off the switch? Currently it I trigger a limit, I have to disabled the limit switch before I can jog off the switch.
-
Look on the settings page and enable auto limit override.
Brett
-
Thanks, I look for that.