Machsupport Forum
Third party software and hardware support forums. => Newfangled Mill Wizard => Topic started by: SScnc on March 30, 2013, 07:22:40 PM
-
First off I'd like to commend the creator of this conversational programming software. I use CAM for a lot of what I do, but there are times where CAM is too complicated for when I need to bang out a quick code. i.e. facing a part.
Anyways, is there anyway to rename operations? It can get confusing to keep everything straight if you have a few operations of the same kind. If not maybe something to add in the future?
Thanks
-
Thanks for the nice comments, it is always nice to hear.
We have talked about allowing a user defined name for each operation. Its kind of on the list for a V2