Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: screwhead on March 30, 2013, 12:49:22 PM
-
Why is it that if try to start Mach 3 from "run from here", the machine goes way off its coordinates? I've done it hundreds of times with different code and it always worked fine. This is a new project, with new code, and it runs fine if I start from the beginning. If, on the other hand, I bring the machine home, and then set a point in the code other than the beginning, the machine forgets its coordinates. Why am I missing?
tony
-
Attach your xml and your code and say which line you are wanting to start from and I will see if I can find a problem.
Hood