Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: valmet58 on March 26, 2013, 06:07:11 PM

Title: mach3 threading speed variations
Post by: valmet58 on March 26, 2013, 06:07:11 PM

i want to know if the new versions of mach3 that include the speed control of the spindle
still sync the Z axis speed to the spindle speed when threading..
with version 6.23 it seems that if the spindle speed decreases the z axis speed stays the same....

Title: Re: mach3 threading speed variations
Post by: Hood on March 27, 2013, 08:14:33 AM

You say "version 6.23" can you expand a little on that as it sounds unfamiliar to me.
Hood

Title: Re: mach3 threading speed variations
Post by: valmet58 on March 27, 2013, 01:26:15 PM

Sorry i meant version 2.63... typo error...sorry

Title: Re: mach3 threading speed variations
Post by: Hood on March 27, 2013, 02:55:34 PM

2.63 is very old, lots of changes have been done to threading in the parallel port driver since then. If I recall it was about 043.036 or so that there was a big change.
Hood