Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: JOHND on March 26, 2013, 12:40:50 PM
-
The computer died on my router which resulted in it replacement. We had to tranfer the files by slaving the hard disk to the new computer.
Th e software will come up but there is no movement of the motors. I see change on the axis registers.
I go into diagnostics and see no changes via the limit switches or e-stop.
I cannot run a driver test (OCX).
Do i have to move the license out of the folder to the desk top?
Any help Is appreciated to get this dead horse running.
JohnD
-
I transfered 2 drives a couple of weeks ago and it removed the XML file & Lic.
dropped those back in Mach folder and all was fine.
Hope this helps...Glen