Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: stevecobb76 on March 18, 2013, 05:23:22 PM
-
http://groups.yahoo.com/group/turbocnc/photos/recent/1641010679/view
I want to use mach3 and get rid of turbocnc. but I need to know first if I can do this and if so, how to I configure it.
there are alot of setting in mach. and I am noob.
-
Hi Steve, I cannot view the picture since I do not have a yahoo account :( Any chance you can upload a pic?
-
sorry. normally I only use yahoo for the turbocnc group. but here is the pic in the attachment