Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: mollinst on March 11, 2013, 02:07:08 PM

Title: Plea for help!!
Post by: mollinst on March 11, 2013, 02:07:08 PM

I'm looking for someone in the Springfield MO area that can help me set up my Mach 3, V-carve Pro, and the machine I'm using. I need a hands-on tutor to explain / teach me as we go and, I'm willing to pay for your time.

I've gotten some terrific advice here, in fact, it was in this forum that V-Carve Pro was suggested, and it did exactly what I needed it to do. What I'm having a problem with now is, well, time for one - this machine will be used to mark a product, and I've had to spend more time on the product than the engraving system. Two, when I try to put all of this together with what I HAVE learned, I get lost in all the stuff that's going on simultaneously and then go back and start from the beginning. Each time, something different isn't right, or isn't working. I'm about to hang myself with the stepper cable harnesses.  :D

Any folks with some time to help, please let me know - I've got to get this thing going.

Thanks so much.

Bill

Title: Re: Plea for help!!
Post by: Chaoticone on March 13, 2013, 09:02:29 AM

How are you comeing along Bill?

Brett

Title: Re: Plea for help!!
Post by: mollinst on March 13, 2013, 09:30:21 AM

Well, as you can see, yours is the only reply so far. :D I've just got too many plates spinning to get this stuff down. Need help - S.O.S.!! :D

Title: Re: Plea for help!!
Post by: Kenneth on March 13, 2013, 10:06:30 AM

what exactly you need done ?  wiring a machine ? getting mach3 to run a machine ?
both ?

Title: Re: Plea for help!!
Post by: Chaoticone on March 13, 2013, 10:07:13 AM

Sent you  PM Bill


Brett