Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: SailFl on March 03, 2013, 11:12:08 AM
-
I just added a spindle to my MechMate and when I run a file it starts cutting before the spindle is ready. Is there a place in Mach or do I need to do it in my Aspire post processor to add a delay to give the spindle time to ramp up to the cut speed before it starts cutting?
Thanks
-
In Mach3, Ports and Pins, Spindle tab, bottom center of the screen. CW spin up I think
-
Gerry
I saw that and I misread it. Thanks, that is exactly what I was looking for. Do you have any suggestions for a good time?
-
Depends on how your spindle is set up. I use 5 seconds with a Super-Pid controlled router.
-
Gerry,
Thanks. It sounds like a good number to start with.