Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: woodspinner on February 28, 2013, 10:50:56 AM
-
Hi, This is probably a dumb question but if you use the on screen fro to speed things up, does it speed up the g0 speed?
i have notice that using it to lower the speed does effect the rapid move speed so does it do the same when you speed itup?
John
-
You can have the rapid locked to feed override but it will never go above 100% even if your FRO goes over 100%.
The option to lock Rapid to FRO is on general Config page.
Hood
-
Thank you Hood
John
-
My X and Y motors are set at 4000 units per minute. Z is set at 2000
Why does the X and Y travel at only 1000 when doing a safe Z move (moving onto the next position)
When the machine is actually milling material the X and Y are traveling at 1500, but the G0 is always at 1000
Cant I get the Rapid feed rate G0 to move at 1500 or even 4000 ??
-
Ok.. Done it. In Mach3. Open the settings tab. Top left hand box called Fast feed overide. It has 0.00 in the box. I changed the numbers to 1000 and left the tab without pressing enter. Now It goes 5x as fast when not cutting material