Machsupport Forum
Mach Discussion => FAQs => Topic started by: troy freeman on February 25, 2013, 02:19:21 PM
-
RESET button will not reset. EXTERNAL E-STOP REQUESTED
-
Do you have any switches or estop buttons wired up?
http://www.machsupport.com/docs/Mach3Mill_Install_Config.pdf
Brett
-
NO
Do you have any switches or estop buttons wired up?
http://www.machsupport.com/docs/Mach3Mill_Install_Config.pdf
Brett
PLEASE HELP. RESET button will not reset. Status- External EStop Requested
-
Go to Config, ports and pins, input signals and see what the active state of estop is. If you change it, can you reset mach?
You can not diasblae estop.
Brett
-
I don't have any limits or e-stops wired up
-
Went to Config.,ports & pins. Tried changing it nothing happend
-
Try setting the estop port and pin to 0.
Brett
-
If you set the Estop input pin to active low, it should reset.