Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: ldsanders2807 on February 21, 2013, 09:18:54 AM

Title: Safe_Z ignored
Post by: ldsanders2807 on February 21, 2013, 09:18:54 AM

I'm working on an initial setup of Mach3 in a new project.  I have all 4 steppers (one is slaved to X) working, E-stop and limit switches are functioning and all seems to be working well.  What is it saying that needs to be changed when the message "Safe_Z ignored, Z already higher than Safe_Z setting?  Another observation is that after an E-Stop is inititated and I click the "send printer home", that the Z axis does not move to the safe Z location.  Thanks

Title: Re: Safe_Z ignored
Post by: Hood on February 21, 2013, 09:56:06 AM

Sounds like your safe Z may be set wrong or it is at least lower than your Z is when you are commanding the moves to zero.
Hood