Machsupport Forum

Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: geast on February 13, 2013, 04:41:19 PM

Title: Dynomotion slave axis problem
Post by: geast on February 13, 2013, 04:41:19 PM

Hello everybody.
I install a dynomotion kflop+kanalog boards together with three analog servo drives. The drives takes +-10V and have incremental encoder for feedback.
The X axis has a slave axis A and it is so configured  on mach. Everything works fine when i do cont.jog from mach or a G command G0 Xsomething to the X axis.
The problem is that when i do a step jog or when i execute a g command G01 Xsomething then the slave axis A does not work. Only the X axis rotate.
Can anybody help?

Title: Re: Dynomotion slave axis problem
Post by: mc on February 15, 2013, 04:09:22 PM

If you've not solved this, your best option is either post on cnczone in the Dynomotion board - http://www.cnczone.com/forums/dynomotion_kflop_kanalog/ or over on the Dynomotion Yahoo Group - http://tech.groups.yahoo.com/group/DynoMotion/

Tom Kerekes (the man behind the KFlop) is very active on both of those.

Title: Re: Dynomotion slave axis problem
Post by: geast on February 15, 2013, 05:24:54 PM

It's solved thank you.