Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: comet on February 13, 2013, 04:12:32 PM

Title: m06 end
Post by: comet on February 13, 2013, 04:12:32 PM

what does m06 end do? is this where i should put the g43? i have an atc on my machine

Title: Re: m06 end
Post by: ger21 on February 13, 2013, 07:38:58 PM

M6End is not used with an ATC.
When Mach3 is configured for M6 to "Stop Spindle, Wait for Cycle Start", M6Start runs when the M6 is called, and M6End runs after Cycle Start is pushed.

When Mach3 is configured for ATC, then only M6Start runs.