Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Ivan_The_Red on February 08, 2013, 08:14:49 PM
-
All,
I just attempted to start the TCP Modbus setup and it wont start, any suggestions ?
Windows Vista - Mach3 Version R3.043.022 ...... everything else is workiing fine.
-
Do you have TCP modbus enabled in General config, ports and pins? Did you close and restart Mach after you enabled it?
Brett
-
I installed the latest lockdown and it seems to work fine now ......
Thanks for the reponse..