Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: Neo20X on February 08, 2013, 04:24:04 PM
-
Hi,
Just a stupid question... a have a DMC1740 galil card, mach3 and everything around but i need the servo design kit.
Is there a freeware available or can anyone provide me a serial for install??
thx ;)
-
Manually tune them with the KI KD & KP commands?
Nosmo
-
Hi,
Ok thx it works... the motor/elmo amplifier is working. I read a lot but i did not understand the correct tuning method.
I use a Elmo Servo Amplifier and use the Elmo Studio to tune the motor. So the motor is allready tuned via the Elmo Studio und saved in the Elmo.
I can see KI and KP values in the amplifiers. When i write this values in the Galil Controller, the Galil doesnt accept them because they are to high.
Is it correct that i have to use the same values in the controller or tune the motor once again from the DMCTerminal with different values???
-
I have only used simple current (torque) mode amplifiers with Galil, the only PID loop is back to Galil, IMO you should not have two PID loops?
N.