Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: jlenelms on February 02, 2007, 07:17:28 PM

Title: HELP
Post by: jlenelms on February 02, 2007, 07:17:28 PM

i just downloaded the newest update and now my cnc plasma table won't reset or run any suggestions would be appreciated

Title: Re: HELP
Post by: Chaoticone on February 02, 2007, 07:32:02 PM

What did you have before? Did you back up your XML and screen set? Did you download the drivers too?

Sent you a Personal message.


Brett

Title: Re: HELP
Post by: jlenelms on February 02, 2007, 07:32:33 PM

no

Title: Re: HELP
Post by: jlenelms on February 02, 2007, 07:35:07 PM

before dynacnc had us with some of the ports and pins but don't know which ones