Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: mollinst on February 03, 2013, 03:12:31 PM
-
I have a small machine running Mach 3 that I would like to use to engrave a logo .005" deep in aluminum. The problem I have is that the artwork is in .jpeg format and I need to convert it to .dxf. For all of my searching out there, I can't find a program that will accomplish this - there MUST be a way to do this. Any help or guidance will be most appreciated.
Thanks.
Bill
-
I would have a look at one of the packages from Vectric.
http://www.vectric.com/products/vcarve-pro.htm
http://www.vectric.com/
Brett
-
Thanks Brett - that looks like it'll do the job.
Bill