Machsupport Forum
Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: dresda on February 03, 2013, 01:47:33 PM
-
When turning the MPG I have off and on signals comming in input 0 & 1 on J5 looking at Vital status screen.
DSPMC plugin set soft encoder, index 2.
Ports and pins, tick MPG#1 leave the rest blank.
No movement, Help.
-
hi Dresda
in ports and pins MPG setting, did you set the counts per unit to 4? mach3 needs this setting.
thanks
Rufi
-
the encoder is 100ppr, I set the the counts to 400?
-
For MPG#1 in Ports and Pins, set Counts/Unit to 4.
make sure in General Config -> Jog Increments in cycle mode, there is no empty slot. all fields should have some value, like 0.0001, 0.001, 0.01 etc.
tomorrow I will check mpg on a machine and let you know if I find any more step required to setup.
regards
Rufi
-
Tried it at 4 and no empty spaces for increments in general config still nothing.