Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Sweep on January 24, 2013, 07:26:04 AM
-
I can't believe it ...or possibly I can. After working over the past 12 months to sucessfully integrate my ATC into Mach3, with untold hours of support from various community members, the thing has now packed in :(
Not sure if there is just one of the solenoids that has stopped working but I suspect it was the original Denford ATC circuit board/processor as the status LED doesn't change when I send either good, or deliberatley bad, code.
Hey ho, looks like I will have to start again and bring all the manual switches back to a I/O card and directly control them from the PC.
Very depressed and disillusioned.
...Sweep