Machsupport Forum
General CNC Chat => Share Your GCode => Topic started by: predriftlongboarding on January 21, 2013, 12:40:51 PM
-
i am new and still having diffuiculties on finishing a project can someone upload this gcode and tell me what actually happens and post the final product thankyou
-
is this what you need? ???
-
yes thats the image but when you carve that how deep does it go and does it actually carve that out? along with how long did it take? Im trying to see what im doing wrong when importing into my 3040t thankyou ya-nvr-no
-
Looking at your Gcode you have not set up you tools properly or setup the depth of cut properly.
The top of your material should be Z0.000. This will make all your CUTS to be below Z0.000 such as Z-0.010 for a .010 cut. IF you are cutting in steps to get to total depth your would use a Step value say .010 and a final depth of Z0.050. That would cut .010" at a time and repeat five times at a lower depth until it reaches .050" deep
You set the rapid height ABOVE the surface such as Z0.500 Approach heights could be closer to the top such as Z0.050
Hope that helps, (;-) TP
-
Hi I am new here and wondering if anyone could shrink the crossbones down.
-
pjjr,
Here is a link to conversion program for scale / mm_inches- inches _mm.
You may want to have a look at the complete thread.
http://www.machsupport.com/forum/index.php/topic,2893.msg39920.html#msg39920
RICH
-
From Mach3 you can use SCALE to make it larger or smaller when you cut it. Just make sure you scale X and Y the same amount.
(;-) TP