Machsupport Forum

Third party software and hardware support forums. => Promote and discuss your product => Topic started by: D.Fahringer on January 31, 2007, 07:32:51 AM

Title: Plans for Jet JTM-1 Knee Mill Servo Retrofit
Post by: D.Fahringer on January 31, 2007, 07:32:51 AM
Hi,  You might want to check out my website which shows my Bridgeport type mill retrofitted with an off the shelf Servo system and using Artsoft's Mach 3.    It has been very cool to hit the wall switch and have everything come to life, the PC, the monitor, the digital readout etc.  Very quiet and accurate also! It is a great time to do a conversion ..... Go to the following web address and check it out!    D.F.

  http://mysite.verizon.net/fahringer/