Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: gearhead1 on January 15, 2013, 01:35:43 AM
-
THANKS FOR LOOKING!!!!!!
I RECIENTLY PURCHASED MACH3. I HAVE ONLY OPENED THE TRIAL VERSION AT THIS TIME. WHEN I OPEN UP MACH3 MILL THE RESET BUTTON IS FLASHING AND A MESSAGE SAY THAT THE E-STOP IS ACTUATED. I DO NOT HAVE THE SOFTWARE CONNECTED TO A MACHINE AND I HAVE NOT UNLOCKED THE DEMO VERSION WITH MY CODE. I AM JUST TRYING TO PLAY AND LEARN THE PROGRAM. SO FAR I CAN'T GET PAST THE E-STOP PROBLEM.
PLEASE HELP IF YOU CAN, I WANT TO HAVE FUN WITH THE REST OF YOU GUYS
THANKS
HARRY
-
Hi Harry,
In Mach3 - Config / Ports & Pins / Input Signals - enable EStop and reverse the 'Active Low' setting. That should enable you to clear the condition.
Tweakie.
-
Harry,
Tick the Emulated box also if not wired to a pin.
RICH
-
THANKS
I AM ON A ROLL NOW
HARRY
-
Great, now if we can just figure out how to get your keyboard fixed as the CAPS button seems to be stuck? ;D
Welcome to the forum ;)
Dave