Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: brian98 on January 13, 2013, 10:23:11 PM
-
I've seen a couple of other threads with the same problem I have: When probing I get the message " probe ignored activated at call for probe" but no one seems to have the answer for what causes this problem or how to avoid it. Has anyone experienced this problem and found the solution?
-
The message is telling you the when the G31 was called the the probe showed it to be in a tripped mode (probe input active).
(;-) TP
-
Thanks. I did not notice the Digitize LED was lit. I'll check for that and wiring problems.
-
Thanks again BR549. With your suggestion, I checked the wiring and found an intermittent ground in one of the probe circuits. Problem fixed.