Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: warped on January 06, 2013, 07:18:48 PM
-
Hi guys,
Apparently I need to do an upgrade to a later version so I can use the latest set of M10/M11 codes for switching a laser.
I have a fully licensed version on disk, R3.043.022 . Where is the UPGRADE for licenced versions located . ( I can only find the DEMO download.Sorry for such a dumb question. ???
Thanks in advance.
-
Download a demo version and install over the top of the old version and just put the license in the installed Mach folder.
RICH
-
OH I FEEL SOOO DUMB.
You say to just put the license in the installed Mach folder.( Where is the license ( On the disc I purchased?)
SORRY, U must be in histerics by now. ( Or crying)
-
Sorry, I could use a good laugh but unfortunately you will need to do better than your question. ;)
Open Mach, click the Help tab, select About Mach3Control and the flyout should show your name and version.
Is that what you are seeing?
RICH
-
Yes it shows my name, but it still shows the old version. I downloaded the new version but installed it to a different folder for now ( C:/ Mach33/mach3)
( I am scared it will wipe all my current settings if i install it into my Mach3 folder ( IT TOOK ME WEEKS TO GET ALL MY SETTINGS CORRECT ) ;D
-
OK I grew some cohunas and put the latest ver download file into the Mach3 folder. All is now well and I have the latest release. Thanks for all your help. I have deleted the Mach33 folder as it was confusing me.... and as u can tell by now .....that's VERY easy to do!! :-[ ;D
-
Happy you got it working.
RICH
-
Just to add since you mentioned you'd hate to lose all your settings, I would personally just make a copy the whole Mach 3 folder and paste it somewhere safe, just in case you mess it up somehow. ;)
Dave