Machsupport Forum

Mach Discussion => Mach Screens => Topic started by: Bodini on January 06, 2013, 06:59:11 PM

Title: Looking for a screen seen before...
Post by: Bodini on January 06, 2013, 06:59:11 PM
I think I recall a screen that had scores and scores of LED's for diagnostic purposes (i mean A LOT of LED's).  Does this ring a bell with anyone?
Title: Re: Looking for a screen seen before...
Post by: RICH on January 06, 2013, 07:03:33 PM
Have you tried clicking the Diagnostics Tab ?
RICH
Title: Re: Looking for a screen seen before...
Post by: Bodini on January 06, 2013, 07:11:59 PM
Hi Rich,

Way more than the diag screen.  I mean a LOT of LEDS.  I swear it was something like every single LED mach has available on one screen.  I must have seen it on this forum, or I imagined it. ;-)

-Nick
Title: Re: Looking for a screen seen before...
Post by: RICH on January 06, 2013, 07:19:26 PM
Are you maybe thinking MAD MACH maintenance  or diagnostics look under Downloads , select Plugins.
RICH
Title: Re: Looking for a screen seen before...
Post by: Bodini on January 06, 2013, 07:35:02 PM
Hey Rich,

No, I don't think thats it (although that may work, dont know, would have to look closer).  It was similar to the Mach3 oem diag screen, but with a crazy stupid amount of leds.  Thanks.

-Nick
Title: Re: Looking for a screen seen before...
Post by: RICH on January 06, 2013, 07:38:03 PM
None that I can recall.... Someone else will probably reply if there is one.
RICH
Title: Re: Looking for a screen seen before...
Post by: 2000mph on January 14, 2013, 05:36:10 PM
Is this what you are thinking of?

http://www.machsupport.com/forum/index.php/topic,15407.0.html

Scroll down to bottom....
Title: Re: Looking for a screen seen before...
Post by: Bodini on January 14, 2013, 08:25:13 PM
Is this what you are thinking of?

http://www.machsupport.com/forum/index.php/topic,15407.0.html

Scroll down to bottom....

No, that's not what i remember, but that sure is pretty and has a lot of info via led's.  I just might try it.  Thanks much!
Title: Re: Looking for a screen seen before...
Post by: DaveCVI on January 21, 2013, 03:42:26 PM
Hi,
You may want to take a look at MachStdMill (MSM). The Hardware diagnostic pages provide both the mach logical signals and the raw pin states for 2 parallel ports. MSM also correctly handles the 2nd port as either input or output configuration.

Much more info avail at www.calypsoventures.com

BTW, the PP diagnostic stuff is included in the free Personal Edition of MSM.

Dave