Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: RC Extreme Power on December 29, 2012, 10:45:53 AM
-
I have been running my machine with Turbo CNC for about three years and decided to run it with Mach3.
Home built machine using Hobby CNC board.
No matter what I try I can not get the steppers to work.
I have watch the set up videos a number of time and can not figure out what I am doing wrong.
Printer port is set
X Y Z pins are set
no stop are on
Below is a screen shot of what I have in the diagnostics screen and in the upper left hand corner none of the X Y Z lights are green and in all the set up videos they are red, No matter what I do I can not get them to turn red. ?????
Thanks for your help.
Milton
-
X Y Z LEDs will be red until you home, then they will go green.
Attach your xml and I will see if there is an issue with it.
Hood
-
Thanks for the replay but got it working, Had the velocity set to high but not happy with the speed, Can only get about 60" a min without it skipping.
Still can not get the lights to go green.
Milton
-
acceleration is likely too high.
Hood