Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: racear2865 on December 17, 2012, 01:03:45 PM
-
I have a mill with Galil 41x4 running. I am totally a novice at this so forgive the stupidity and somtimes stupid question. There are 2 item I would luv to pursue.
1: What Mach3 wizards can I run thru the Galil setup.
2: Can I use the Homann MP-03 with this setup theu the 9 pin setup.
racear
-
racecar,
I have had trouble with the Modbus based stuff that needs to pass data quickly to Mach. There is a 100ms latency that may cause jerky motion should not be a problem when Mach4 is out). I have been successful with the MPG-04 from CNC4PC. Any MPG will likely need brain files to get proper communication with Mach.
Cheers,
Kenny
-
Now Kenny, u just aint makin me feel warm inside with that answer. Can we discuss it.
racear
-
Not to worry you, the hardwired MPG (into the Galil inputs) works very well indeed and the brain files aren't too hard to do either. I just am not comfortable with motion depending on a device that only communicates every 100ms either. Think broken tools or worse!