Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: armitage on December 14, 2012, 11:29:24 AM

Title: Installation problem- "No Driver sensed installed"-
Post by: armitage on December 14, 2012, 11:29:24 AM

I am installing Mach3 on a Windows 7 64bit PC and I get a screen that says "No driver sensed installed. Run driver test."  After hitting the yes button it goes with no noticeable delay to the installation finished screen but the program is not engaging the steppers.  I've retried from the DriverTest.exe file with the same result.  Any ideas about the cause of the problem?

Title: Re: Installation problem- "No Driver sensed installed"-
Post by: armitage on December 14, 2012, 11:48:43 AM

So I just read the post about the parallel port driver not working with a 64 bit system.  Can someone explain the work arounds for that situation?

Title: Re: Installation problem- "No Driver sensed installed"-
Post by: BR549 on December 14, 2012, 12:42:25 PM

Get a 32 bit OS or an outside motion controller that works with Mach3.

(;-) TP