Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: bdrotaru on December 14, 2012, 02:13:24 AM
-
Hi.
I own an CNC Plasma table.
I keep forgoting activate THC sensor button after Mach3 launched.
There is a way to activate automaticaly or remain activated after previous run?
-
If the THC sensor button is a VB button, put that code in a macro (M code) and call the macro at the beginning of the program. If the button is a Mach3 OEM button do the same thing but in the macro call doOEMButton(*********).