Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: orangejbird on December 11, 2012, 02:45:45 PM
-
Plasma Torch moves up and down slightly about 3 times a second. Looks like it's trying to sew. Changing tip volts changes the height the bounce happens at. Bounces about 1/32"
Mach3
I'm probably missing a THC setting of some kind?
Any suggestions?
DynaCNC w/4000 series controls, Cutmaster 52.
-
Slow Down the THC speed % , The Z is moving faster than the THC can compensate and it oscilates.
(;-) TP