Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: Jack Hoffa on December 11, 2012, 01:54:24 AM

Title: How to Jog X+ with an external switch
Post by: Jack Hoffa on December 11, 2012, 01:54:24 AM

Is there a way to jog X+ (Right arrow) from an external switch without a keyboard emulator?

Is there an OEM code for that or is this a dumb question?

I am running 2 screen functions with external switches, so OEM codes work there.

Could someone explain the EMULATED input check box on Input pins- How that works -  could use 2 more external switches - I'm Poor at electronics

Thanks  Jack Hoffa
jack.darlene.hoffa@roadrunner.com
 ::)

Title: Re: How to Jog X+ with an external switch
Post by: Hood on December 11, 2012, 03:06:44 AM

Put your switch to an input pin then go to ports and Pins then Inputs and scroll down near the bottom and you will see the Jog button options. Set the port and pin number you have the switch connected to for x++ and you are done :)
Hood

Title: Re: How to Jog X+ with an external switch
Post by: Jack Hoffa on December 11, 2012, 01:12:24 PM

THANKS SOO MUCH
I didn't go down the list far enough

Jack   ::)