Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: DICKEYBIRD on December 09, 2012, 05:05:45 PM
-
What's the least buggy version of Mach 3 Turn? Mine is R3.043.022
I've finally got my opto home switches up & working on the ORAC and want to get this thing into a solid configuration. I'm pretty sure the weird things it's doing are due to my ignorance but I want to make sure I'm starting with as solid a version as possible as I go forward. What version are you guys using that actually make parts consistently with your lathes? I'm using a solid PC with a good PP (no external controller.)
-
For threading should be > than 3.042.033. You may want to check Ron's recomendations if using the NFS Turn wizard.
RICH
-
Thanks Rich, I'll install .033 and go from there.
-
Hmmm, went to the old versions page and their isn't an .033 version listed??